Configuring and managing ports and VLANs 95Nortel WLAN—Security Switch 2300 Series Configuration GuideRemoving a port nameTo remove a port name, use the following command:clear port port-list nameConfiguring media type on a dual-interface gigabit ethernet port(2380 only)The gigabit Ethernet ports on a 2380 switch have two physical interfaces: a 1000BASE-TX copper interfaceand a 1000BASE-SX or 1000BASE-LX fiber interface. The copper interface is provided by a built-in RJ-45connector. The fiber interface is optional and requires insertion of a Gigabit interface converter (GBIC).Only one interface can be active on a port. By default, the GBIC (fiber) interface is active. You can configurea port to use its the RJ-45 (copper) interface instead.If you set the port interface to RJ-45 on a port that already has an active fiber link, WSS Software immediatelychanges the link to the copper interface.To disable the fiber interface and enable the copper interface on a 2380 port, use the following command:set port media-type port-list rj45To disable the copper interface and reenable the fiber interface on a 2380 port, use the following command:clear port media-type port-listTo display the enabled interface type for each port, use the following command:show port media-type [port-list]To disable the fiber interface and enable the copper interface of port 2 on a 2380 switch and verify the change,type the following commands:2380# set port media-type 2 rj452380# show port media-typePort Media Type===========================================================1 GBIC2 RJ453 GBIC4 GBIC