672 Appendix A:Troubleshooting a WSSNN47250-500 (320657-F Version 02.01)Figure 1. WSS restart switch location2 When you see descending numbers on the console, press q, then press Enter.3 Type the following command at the boot> prompt:boot> boot OPT+=defaultIf you do not type the command before the reset cycle is complete, the WSS returns to the state it was in before yourestarted it.Once you have entered the command, the WSS returns to its initial unconfigured state. For information on how toconfigure the WSS, see “First-time configuration via the console” (page 72).For model 2382, 2360/2361, you also can reconfigure basic parameters using the Web Quick Start. Use a web browser toaccess IP address 192.168.100.1.Configuring and managing the system logSystem logs provide information about system events that you can use to monitor and troubleshoot WSS Software.Event messages for the WSS and its attached APs can be stored or sent to the following destinations:• Stored in a local buffer on the WSS• Displayed on the WSS console port• Displayed in an active Telnet session• Sent to one or more syslog servers, as specified in RFC 3164The system log is a file in which the newest record replaces the oldest. These entries are preserved in nonvolatilememory through system reboots.Caution! Use an enable password that you will remember. If you lose the password, theonly way to restore it causes the system to return to its default settings and wipes out theconfiguration.121 22 LinkAPMgmtConsoleRstLinkAP2 3 4 5 6 7 8 9 1011 12 13 14 15 16 17 18 19 20100-240V50/60 Hz8A MAXDISCONNECTALL POWERBEFORESERVICINGRestart switch840-9502-0026
