328 Configuring Auto-RFNN47250-500 (320657-F Version 02.01)Tune Power: no Tune Channel Interval: 3600Tune Power Interval: 600 Power ramp interval: 60Channel Holddown: 300 Countermeasures: noneActive-Scan: yes RFID enabled: noWMM Powersave: no QoS Mode: wmmNo service profiles configured.To display the Auto-RF settings that you can configure on an individual radio, use the following commands:show ap config [port-list [radio {1 | 2}]]show ap config [ap-num [radio {1 | 2}]]To display the Auto-RF and other individual radio settings on radio 1 of a directly connected AP access portconnected to WSS port 2, type the following command:WSS# show ap config 2 radio 1Port 2: AP model: 2330, POE: enable, bias: high, name: MP02boot-download-enable: YESforce-image-download: NORadio 1: type: 802.11g, mode: disabled, channel: 6tx pwr: 1, profile: defaultauto-tune max-power: defaultTo display the Auto-RF and other individual radio settings on both radios on the Distributed AP configured onconnection 1, type the following command:WSS# show ap config 1Ap 1: serial-id: 12345678, AP model: 2330, bias: high, name: AP01fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3boot-download-enable: YESforce-image-download: NORadio 1: type: 802.11g, mode: disabled, channel: 6tx pwr: 1, profile: defaultauto-tune max-power: defaultRadio 2: type: 802.11a, mode: disabled, channel: 36tx pwr: 1, profile: defaultauto-tune max-power: defaultDisplaying RF neighborsTo display the other radios that a specific Nortel radio can hear, use the following commands:show auto-tune neighbors [ap ap-num [radio {1 | 2| all}]]show auto-tune neighbors [ap ap-num [radio {1 | 2| all}]]The list of radios includes beaconed third-party SSIDs, and both beaconed and unbeaconed Nortel SSIDs.To display neighbor information for radio 1 on the directly connected AP on port 2, type the followingcommand: