Configuring APs 271Nortel WLAN—Security Switch 2300 Series Configuration GuideAssigning a radio profile and enabling radiosTo assign a radio profile to radios, use the following command:set {ap port-list | ap ap-num} radio {1 | 2} radio-profile name mode {enable | disable}To assign radio profile rp1 to radio 1 on ports 5-8, 11-14, and 16 and enable the radios, type the followingcommand:WSS# set ap 5-8,11-14,16 radio 1 radio-profile rp1 mode enablesuccess: change accepted.To assign radio profile rp1 to radio 2 on ports 11-14 and port 16 and enable the radios, type the followingcommand:WSS# set ap 11-14,16 radio 2 radio-profile rp1 mode enablesuccess: change accepted.To disable radio 1 on port 6 without disabling the other radios using radio profile rp1, type the followingcommand:WSS# set ap 6 radio 1 radio-profile rp1 mode disable(To disable or reenable all radios that are using a radio profile, see “Disabling or reenabling all radios using aprofile” (page 271).)Disabling or reenabling radiosYou can disable or reenable radios on a radio profile basis or individual basis. You also can reset a radio to itsfactory default settings.(To disable or reenable radios when assigning or removing a radio profile, see “Assigning a radio profile andenabling radios” (page 271).)Enabling or disabling individual radiosTo disable or reenable an AP radio, use the following command:set {ap port-list | ap ap-num} radio {1 | 2} mode {enable | disable}To disable radio 2 on port 3 and 7, type the following command:WSS# set ap 3,7 radio 2 mode disablesuccess: change accepted.Disabling or reenabling all radios using a profileTo disable or reenable all radios that are using a radio profile, use the following command:set radio-profile name [mode {enable | disable}]
