Configuring APs 273Nortel WLAN—Security Switch 2300 Series Configuration GuideDisplaying AP informationYou can display the following AP information:• AP and radio-specific configuration settings• Connection information for Distributed APs configured on a WSS• List of Distributed APs that are not configured on a WSS• Connection information for Distributed APs• Service profile information• Radio profile information• Status information• Information about static IP addresses on Distributed APs• Statistics countersDisplaying AP configuration informationTo display configuration information, use the following commands:show ap config [port-list [radio {1 | 2}]]show ap config [ap-num [radio {1 | 2}]]The command lists information separately for each AP.To display configuration information for an AP on WSS port 2, type the following command:WSS# show ap config 2Port 2: AP model: 2330, POE: enable, bias: high, name: MP02boot-download-enable: YESforce-image-download: YESRadio 1: type: 802.11g, mode: disabled, channel: 6tx pwr: 1, profile: defaultauto-tune max-power: defaultRadio 2: type: 802.11a, mode: disabled, channel: 36tx pwr: 1, profile: defaultauto-tune max-power: defaultTo display configuration information for a AP configured on connection 1, type the following command:WSS# show ap config 1ap 1: serial-id: 12345678, AP model: 2330, bias: high, name: ap01fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3boot-download-enable: YESforce-image-download: YESRadio 1: type: 802.11g, mode: disabled, channel: 6tx pwr: 1, profile: defaultauto-tune max-power: defaultRadio 2: type: 802.11a, mode: disabled, channel: 36tx pwr: 1, profile: defaultauto-tune max-power: default