Nortel CallPilot User Manual

Also see for CallPilot: User guide Supplementary guide Configuration manual User guide Reference guide

Contents

TD/480JCT-2T1 card function 137—End—Manually setting T1 card manual termination jumpersManually set T1 card manual termination jumpers only on the last card atthe end of the CTbus.ATTENTIONRisk of equipment damageDo not install this jumper on any of the other T1 cards.Apply a jumper between pins 3 and 4 of the P700 header on theIntel/Dialogic D/480JCT-2T1 card. The diagram below shows a detail ofthe T1 card.D/480JCT-2T1 cardTo test the D/480JCT-2T1 cardTest the D/480JCT-2T1 card using the Universal Dialogic Diagnostic (UDD)utility.Note: Before running this utility, you must stop essential services.All call processing ceases and you must restart the system after thediagnostics are complete.Step Action1 Stop the CallPilot HAL Monitor service. Refer to "To start or stop acomponent" (page 57) for instructions.Nortel CallPilot1002rp Server Maintenance and DiagnosticsNN44200-701 01.02 Standard5.0 4 April 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.