152 Appendix A WLAN Application Gateway 2246Procedure 13Installing the WLAN Application Gateway 2246Step Action1 Place the WLAN Application Gateway 2246 on a shelf or convenientlocation.Note: The WLAN Application Gateway 2246 is physicallyconnected to the Ethernet switch and can be placed in anyconvenient location within 325 ft (100 m) of the switch. It canalso be rack-mounted.2 Connect the power plug from the WLAN Application Gateway 2246power adapter to the power jack on the front (or rear) of the box.ATTENTIONIMPORTANTUse only the power adapter provided by Nortel.3 Plug the power adapter into an outlet or outlet strip.4 Apply power to the WLAN Application Gateway 2246.5 Ensure that the ERROR LED is off and LED 1 is blinking.—End—Configuring the WLAN Application Gateway 2246 IP addressYou must connect to the WLAN Application Gateway 2246 through a serialconnection to configure the IP address and the network parameters. Afterthis is done, you can perform administration and further configurationthrough a Telnet connection using the Administration Console.Follow the steps in Procedure 14 "Connecting to the WLAN ApplicationGateway 2246 through a serial port" (page 152) to make a serial connectionto the WLAN Application Gateway 2246.Procedure 14Connecting to the WLAN Application Gateway 2246 through a serial portStep Action1 Using a DB-9 female, null-modem cable, connect the WLANApplication Gateway 2246 to the serial port of a terminal or PC.2 Run a terminal emulation program (such as HyperTerminal) or use aVT-100 terminal with the following configuration:Nortel Communication Server 1000WLAN IP Telephony Installation and CommissioningNN43001-504 01.02 StandardRelease 5.0 15 June 2007Copyright © 2004-2007, Nortel Networks.
