160 Appendix A WLAN Application Gateway 2246Figure 28WLAN Application Gateway 2246 connection to Application Server through a modemContinuing configuration through TelnetAfter the IP address for the WLAN Application Gateway 2246 is configured,the WLAN Application Gateway 2246 reset and connected to the LANand the Application Server, Telnet can be used to continue the WLANApplication Gateway 2246 configuration.Connecting through TelnetConnection to the WLAN Application Gateway 2246 can be done throughthe network using Telnet. Telnet can only be used after the WLANApplication Gateway 2246 IP address is configured.The Telnet method of connection is used for routine maintenance of thesystem for both local and remote administration, depending on the network.Follow the steps in Procedure 18 "Connecting to a WLAN ApplicationGateway 2246 through Telnet" (page 160) to connect to a WLAN ApplicationGateway 2246 through Telnet.Procedure 18Connecting to a WLAN Application Gateway 2246 through TelnetStep Action1 Run a Telnet session to the IP address of the WLAN ApplicationGateway 2246.2 Log in to the WLAN Application Gateway 2246.The NetLink OAI System screen appears.Note: Because the WLAN Application Gateway 2246 is initiallyconfigured, the NetLink OAI System screen now has somedifferent options displayed.—End—Nortel Communication Server 1000WLAN IP Telephony Installation and CommissioningNN43001-504 01.02 StandardRelease 5.0 15 June 2007Copyright © 2004-2007, Nortel Networks.
