WLAN Application Gateway 2246 installation 974 Repeat steps 1-3 for each additional WLAN IP Telephony Manager2245. The mounting plate is designed to provide the correctminimum spacing between units. When mounting multiple units,stack the units in the rack as closely as possible.—End—LAN connectionUse an RJ-45 cable to connect the NETWORK port on the WLAN IPTelephony Manager 2245 to the connecting port on the Ethernet switch.Power connectionFollow the steps in Procedure 4 "Connecting the power" (page 97) toconnect the power to the WLAN IP Telephony Manager 2245.Procedure 4Connecting the powerStep Action1 Connect the power plug from the AC adapter to the jack labeledPWR on the WLAN IP Telephony Manager 2245.WARNINGUse only the provided Class II AC adapter with output24V DC, 1A.2 Plug the AC adapter into a 110V AC outlet to supply power to theWLAN IP Telephony Manager 2245.The system cycles through diagnostic testing and the LEDs blink forapproximately one minute.3 When the system is ready for use, verify the following:a. ERROR LED is off.b. Status 1 is blinking.—End—WLAN Application Gateway 2246 installationFor information about installing the optional WLAN Application Gateway2246, see Appendix "WLAN Application Gateway 2246" (page 147).Nortel Communication Server 1000WLAN IP Telephony Installation and CommissioningNN43001-504 01.02 StandardRelease 5.0 15 June 2007Copyright © 2004-2007, Nortel Networks.
