Installing an AMG 9RLFH $ODUP 6\VWHPAFP-300/AFP-400 Installation PN 50253:C1 05/22/97 4-7$7* 7HUPLQDO&RQQHFWLRQVFigure 4-4 shows ATG-2 terminal connections:)LJXUH $7* 7HUPLQDO &RQQHFWLRQVTable 4-7 lists descriptions for each of the ATG-2 connections:Table 4-7 Descriptions of ATG-2 Connections1$& &RQQHFWLRQ7RQH 6WDUW ,QSXW/RZOHYHO $XGLR2XWSXW&RQQHFWLRQV/RZOHYHO $XGLR ,QSXW DQG 7KURXJK&RQWURO +DUQHVV3RZHU +DUQHVV 2XW&RQILJXUDWLRQ6ZLWFKHV6WDWXV/('V0LFURSKRQH&RQQHFWRU3$*( 6(/(&76ZLWFK53RZHU +DUQHVV ,Q7URXEOH ,QSXW1RWH &XW 5 IRU VLQJOHFKDQQHO RSHUDWLRQInput/Output Connections Used forTrouble Input P4 Connecting trouble output contacts from an audio amplifier.A closure signals the ATG-2 when a device is in trouble. Thetrouble signal is relayed through the Notification ApplianceCircuit connection.Low Level AudioInput and ThroughP3-1 to P3-6 When using the ATG-2 for remote paging, the low level audiooutput from the main ATG-2 or AMG is passed through theremote ATG-2, then passed on to the audio amplifiers.NotificationAppliance CircuitP3-7P3-8Connecting 24 VDC regulated power if using NotificationAppliance Circuits.Power Harness In P1 Connecting to the MPS-400 (J1) for providing power to theATG-2.Control Harness P5 Connecting to P4 on a Fire Fighter’s Telephone (if installed).Low Level AudioOutput ConnectionsP5 - FFT7P6 - EVACP7 - ALERTHarnessing the ATG-2 audio signal to audio amplifiers in thesame cabinet through P6 or P7; or wired to the audioamplifiers in other cabinets through P8.Power Harness Out P2 Connecting to another power supply in the power supplychain.www.PDF-Zoo.com