$SSHQGL[ $ $QQXQFLDWRUV Annunciator Selection GroupsA-2 AFP-300/AFP-400 Installation PN 50253:C1 05/22/97$QQXQFLDWRU6HOHFWLRQ*URXSV2YHUYLHZThe control panel’s annunciation points are divided into nine ACS selection groups of64 points. Table A-1 contains a list of the ACS Selection Groups, what an annunciatordisplays if a group is selected, and where to locate a list of the 64 points within the ACSSelection Groups.7DEOH $ $&6 6HOHFWLRQ *URXSVNotes on ACS Mode for System and Point Annunciation:When using an LCD-80 in ACS mode for system annunciation, you must assign ACSSelection Group 1 to the LCD-80’s start address. (For instructions on assigning ACSSelection Groups, refer to the AFP-300/AFP-400 Programming Manual.) LCD-80sused in ACS mode for point annunciation can use other ACS Selection Groups for theirstart address. Note, however, that annunciators configured for point annunciation:• Do not respond to any status change, including system alarm or system trouble,that is not within its ACS Selection Group.• Do mask status changes for point number 1 of the start address selection.• Do not respond to System Reset, Acknowledge, or Alarm Silence.• Do not use the battery saving feature (100 mA battery load).ACSSelectionGroupAnnunciator Display Refer to...1 CPU Status and Zones 1-56 Table A-2 on page A-32 Zones 57-99, NAC Ckts 1-4 and 16Special ZonesTable A-3 on page A-43 Intelligent Modules 101 to 164 Table A-4 on page A-54 Intelligent Modules 201-264 (AFP-400only)Table A-5 on page A-65 Intelligent Modules 165-196 and265-296 (AFP-400 only)Table A-6 on page A-76 Detectors 101 to 164 on SLC loop 1 Table A-7 on page A-87 Detectors 201-264 on SLC loop 2(AFP-400 only)Table A-8 on page A-98 Detectors 165-196 and 265-296(AFP-400 only)Table A-9 on page A-109 NAC/Panel Output Circuit Modules(64 points)Table A-10 on page A-11* or 0 Annunciator Not Installed At Address N/Awww.PDF-Zoo.com