Specifying Settings From the Control Panel 3cm2520 3-89Specifying Settings From the Control Panel Chapter 3E-Mail TX (SMTP) screen 3/4E-Mail TX (SMTP) screen 4/4SMTP Detail screenTo specify E-Mail TX (SMTP) settings1 In the Administrator Setting screen, touch [5 Network Setting]. (Refer topage 3-8 for more details.)2 In the Network Setting screen, touch [8 E-Mail Setting].Item DescriptionConnection Timeout If the operation delays while sending mail to the SMTPserver, mail transmission is automatically aborted after aspecified time elapses. Set the time from the point whenthe transmission stops to the point when the mailtransmission is to be aborted. To change the value, pressthe [C] (clear) key, and then use the keypad to type in thevalue (between 30 and 300 seconds).Server Capacity Sets the maximum capacity that the SMTP server canreceive per mail. To change the value, press the [C] (clear)key, and then use the keypad to type in the value (between1 and 100 MB). To apply no restriction, touch [Unlimited].Item DescriptionSSL Settings Specify whether to use SSL during e-mail transmission.When SSL is used, the content that is sent is encrypted.Port Number (SSL) Specify the port number for using SSL. To change the val-ue, touch [Input], press the [C] (clear) key, and then use thekeypad to type in the value (between 1 and 65535).Port Number Specify the port number for the e-mail transmission. Tochange the value, touch [Input], press the [C] (clear) key,and then use the keypad to type in the value (between 1and 65535).Item DescriptionPOP Before SMTP Select whether to use POP Before SMTP authentication.SMTP Authentication Select whether to use SMTP authentication. If [ON] istouched, the screen for entering the SMTP authenticationinformation appears. For details on specifying the setting,refer to “SMTP Authentication” on page 3-94.POP Before SMTP Time Specify if using POP Before SMTP authentication. Tochange the value, press the [C] (clear) key, and then use thekeypad to type in the value (between 0 and 60 seconds).
