3-8FAXING THE FRONT AND BACK SIDES OF ACARD ON ONE SHEET OF PAPER (CARD SHOT)When faxing a card, this function allows you to combine the front and back sides on a single sheet of paper. To usethis function, the original must be scanned on the document glass.USING CARD SHOT1 In fax mode, touch the [SPECIAL MODES]key.If the address book screenappears, touch the[CONDITION SETTINGS]key to display thecondition settings screen(page 1-5).2 Touch the [CARD SHOT] key.The card shot screenappears.3 Enter the X dimension (width) and Ydimension (length) of the original with thekeys. X (width) is initially selected. Enter X and thentouch the Y ( ) key to enter Y. To return the X and Y values to the initial settingsconfigured in the key operator programs, touch the[SIZE RESET] key. ( "CARD SHOT SETTINGS" onpage 15 of key operator's guide) To have the images enlarged or reduced by asuitable ratio based on the entered original sizeand transmission size so that the front and backsides fit into the transmission size, touch the [FITTO SEND SIZE] key. Even if a large transmissionsize is selected and the original is extremely small,the image will be enlarged to 400% or less. To cancel the card shot function, touch the[CANCEL] key.The front and back of the cardare printed on one sheet ofpaper.Front of cardOriginalTransmission using the "cardshot" special modeBack of cardCARD SHOTYour machine The other machineTransmission toother machineNOTEA ratio cannot be specified and the image cannot be rotated when using this function. Transmission is not possibleif the image is too large to fit into the transmission size.TO RECEPTIONMEMORY:100% QUICK FILEADDRESS REVIEWSPECIAL MODESFILESUB ADDRESSMODE SWITCHERASE DUAL PAGESCAN2in1 CARD SHOTSIZE RESETCANCEL OKFIT TOSEND SIZE
