Adjusting the DensityYou can adjust the density in seven levels.1. Press [Scan] or the (SCAN) button.The touch panel display switches to the scan top screen.MemoTo display the home screen, press the (HOME) button.2. Set a document in the ADF or on the document glass.3. Select a scan method.Sending Scanned Data as an E-mail Attachment (Scan to E-mail)Saving Scanned Data in USB Memory (Scan to USB Memory)Saving Scanned Data in a Shared Folder (Scan to Shared Folder)Specify a destination by following the procedure for the selected scan method.The (START) button lights up.4. Follow the procedure in the table below for the selected scan method.Scan method Display on the touch panel and operation proceduresScan To E-mail [Image Settings] tab > [Image Settings] > [Density]Scan To USB Memory [Image Settings] tab > [Density]Scan To Shared Folder [Image Settings] tab > [Density]5. Select density.Available document type settings:Memo[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or [-3] (lightest).6. Change other settings if necessary, and then press the (START) button.Scanning starts.132
