Installing Your Machine- 20 -4 When the screen prompting you to turnoff the power switch appears, press the<O> (off) side of the power switch toturn off the power switch.Note Turn the power off, and when turning the power back onagain, push the power switch to the <|> side after waitingfor a few seconds. When the machine is not used forlong timeWhen the machine is not used for long time dueto holidays or trips, pull the power cord from thesocket. In addition, install the stopper release inthe fuser unit.Memo The machine does not have functional failures if removingthe power plug for long time (more than 4 weeks).Power Save Mode and Sleep ModeThe two-phase power saving mode enables youto save the power consumption of the machine. Power Save ModeWhen your machine is not used for a certainperiod of time, it automatically enters a powersaving mode to reduce the power consumption.You can enter the power saving mode manuallyby pressing the <POWER SAVE> key on theoperator panel.The <POWER SAVE> key lights up while in themode.Memo By factory default, the time interval to enter the powersaving mode is set to 30 minutes. You can change the timeinterval by pressing the <SETTING> key on the operatorpanel and selecting [Admin Setup] > [Management] >[Power Save] > [Power Save Time]. Sleep ModeYour machine goes from the power saving modeinto the sleep mode after a set period of time. Inthe sleep mode, the status of your machine isalmost the same as when it is turned off.The <POWER SAVE> key blinks while in thesleep mode.Note The machine does not enter the sleep mode if an erroroccurs. If time-set transmission is scheduled, the machine will notgo into sleep mode. If the fax transmission is waiting for a redial, the machinecannot enter sleep mode.Memo By factory default, the time interval to enter the sleepmode is set to 10 minutes. You can change the timeinterval by pressing the <SETTING> key on the operatorpanel and then selecting [Admin Setup] >[Management] > [Power Save] > [Sleep Time].Reference For more detailed information on sleep mode, please referto User's Manual Advanced. Returning to the Standby ModeTo return the machine to the standby mode fromthe power saving or sleep modes, press the<POWER SAVE> key on the operator panel.Memo When your machine receives a print job from a computeror other devices, it automatically returns to the standbymode.
