MPS930b User’s Guide> 302. Select Manual Feed.3. Click OK.MEDIA CHECKBy default the printer selects the input source based on the papersize requested. If the paper size requested is not loaded in any inputtray, the printer feeds from the default input tray. Media Type is nota factor in the printer selection of the input tray. When Media checkis enabled, the printer first checks the default input source to see ifit has media loaded that matches both the driver requested mediatype and paper size. If the default input tray does not contain therequested media, the printer searches the other input trays to findone that has media matching the requirements. If none is found, theprinter stops and asks you to load the requested media in the defaultinput tray. You can acknowledge this by pressing Start whether thecorrect media is in place or not. Or you can put the correct media ina tray and then use the Operator Panel to set the media type for thattray. If it is Tray MPF or the size is not auto detectable, you can alsoset the paper size. Otherwise, the printer can auto detect the papersize.The most convenient way to enable this feature is by using yourPrinter Properties. You may also enable this feature at the OperatorPanel or by using the EWS.To enable media check:1. Select the Paper Feed button in the Setup tab within yourPrinter Properties.The Paper Feed Options window appears.2. Select Media Check.3. Click OK.4. Click OK.JOB OFFSETThe Stacker Main and Standard Top Bincan place sheets in alternatepositions to separate one print job from another. This is called joboffsetting. When selected, the output position changes after the finalsheet of the print job is printed. The next job is the offset (shifted abit) to keep it separate from the previous print job.