Problem Solving91EnglishNote:If the image drum unit has reached the end of its life,you will also use this function to reset the drumcounter. Refer to Replacing Image Drum Unit abovefor more information.1. Press the Select Function key.2. Press the 7/Counter Display One Touch key. The display showsDRUM COUNT.3. Press the NO key. The display shows the PRINT COUNT.4. Press the NO key again. The display shows the SCAN COUNT.5. Press the Select Function key to finish.Problem checklistYour fax machine is a complex machine with many features and functionswhich allow it to operate in different ways. Many problems you experiencemay be due to improper programming. If you are experiencing a problem,read through the list of problems and solutions before calling your dealer.Your telephone does not ring if your fax machine is set tel/faxanswering mode and the incoming call is a voice call. This is normal. Inthe tel/fax answering mode, your fax machine answers the incoming calland detects if the call is a voice call or a fax call. If the call is a voice call,your fax machine will ring, but your telephone will remain silent. It isrecommended that you only use tel/fax answering mode if your telephoneis located near the fax machine.The display is blank. Check that the power switch is on. Check the powercord to make sure that it is firmly plugged in. Check your wall outlet tomake sure that it has power.Nothing happens when you press the control panel keys. Turn the faxmachine off, wait 10 seconds, then turn it on again.The display tells you to replace paper even though there is paper in thepaper cassette. Take the paper cassette out and make sure that the paperis firmly stacked in the tray. Push the paper firmly under the plastic tabson the edge of the tray. Check for a paper jam in the fax machine.Your documents jam. Check the document for wrinkles, tears or otherdamage. Make sure there are no staples or paper clips and that the paper isclean and dry. Make sure the document is not wider than your fax machine