Panasonic AJ-D610WA Operating Instructions Manual

Contents

– 46 –ECU AQOUTPUT GAINWHITEBALANCEAUTO W/BBALANCE90-3CAMERATESTBARABPREAWBABBMANUAL AUTO(dB)SHUTTERPAINTINGONOFFON1/2501/1251/1001/5001/10001/2000OFFECUR BR BMASTERPEDESTALIRISONOFFPAGEITEMUPDWN ONSELECT CONTROL STORESET UPGAINBLACK-Connecting the AQ-EC1 Extension Control Unit (Option)Connecting the AQ-EC1 extension control unit (option) allows a portion of the camera sectionfunctions to be operated by remote control.When the AQ-EC1 is connected and the POWER switches of the unit and AQ-EC1 are set to ON,the unit automatically enters remote control mode.The handling instructions included with the AQ-EC1 describe operations for when the AQ-EC1 isconnected to an AQ series digital camera.When the AQ-EC1 is connected to the AJ-D610WA, some functions differ, and some featurescannot be used.|Notes{¡The POWER switches of the unit and AQ-EC1 must be set to OFF before the 6-pin cable isconnected or disconnected.¡When OFF has been set for ECU DATA SAVE on the SUB menu CAMERA SW MODE pageof MAIN menu screen 2 of 4¡All adjustments and settings made using the switches and controls on the menu setting sectionof the AQ-EC1 are erased when the unit’s POWER switch is set to OFF. Neither is it possible tosave any of the adjustments and settings—except for the menu settings—performed using theAQ-EC1’s switches and controls on the setup card. However, when the AQ-EC1 is connectedagain, these settings return to the AQ-EC1 settings.(Menu contents set with the menu setting section are saved.)¡When ON has been set for ECU DATA SAVE on the SUB menu CAMERA SW MODE pageof MAIN menu screen 2 of 4The adjustments and settings performed using the switches and controls on the AQ-EC1’s menusetting area will not be lost even when the unit’s POWER switch is set to the OFF po-sition.|Note{The functions of the AQ-EC1 are limited as follows.¡The STORE switch does not function.(If the menu settings are changed while the AQ-EC1 is connected to the AJ-D610WA, the newmenu settings are saved automatically as soon as the changes are made.)¡Note that the AQ-EC1 gain switch displays p3, 0 and 9 correspond to L, M and H, and theOUTPUT switch settings CAMERA, TEST and BAR to CAM/AUTO KNEE ON, CAM/AUTOKNEE OFF and BAR for each main unit.¡The Synchro scan and Super V modes cannot be used while the AQ-EC1 is connected to theunit.¡The lens iris (IRIS) control of the AQ-EC1 is valid only when the lens iris AUTO/MANUAL selec-tor is set to AUTO.6-pin CableECU ConnectorAQ-EC1