– 78 –Setting the Electronic ShutterSetting the Shutter Mode/Speed¡The shutter speed during shutter mode and standard mode is set by the SHUTTER switch.¡During SYNCHRO SCAN mode, the shutter speed can be set beforehand at the SYNCHROSCAN page of the setting menu. In the SYNCHRO SCAN mode, the shutter speed can easily bechanged using the SYNCHRO (“o” and “p”) buttons. (It can also be set using the UP or DOWNbutton.)¡The shutter speed selection range can be limited to the required range and whether to usespecial operation modes (SYNCHRO SCAN or SUPER V) can be selected at the SHUTTERSPEED page of the setting menu.1 Set DISP MODE on the “VF DISPLAY” SUB menu page of MAIN menu screen 2 of 4 to “2” or“3” by following the steps outlined in “Changing the Display Mode” (page 62).2 Press the SHUTTER switch from the ON position to the SEL side. The current shutter settingappears in the setting change message display position on the viewfinder screen.Ex.: 1/120, 1/60.8, etc.3 Press the SHUTTER switch to the SEL side repeatedly until the desired mode or speed ap-pears. When all modes and speeds can be displayed, the display changes in the order shownbelow. If the required shutter speeds and modes have been designated beforehand, only thedesignated speeds or modes appear.¡When the unit is shipped from the factory, SUPER V mode is not specified and is thereforenot displayed.SHUTTER SwitchSYNCHRO SCAN ModeStandard ModeSUPER V Mode1/100 1/120 1/250 1/500 1/1000 1/2000
