Panasonic BT-LH910G Operating Instructions Manual

Also see for BT-LH910G: Brochure Brochure Brochure & specs Operating instructions

139 REAR TALLYS (red)Can be lit by a control signal from a GPI/camera.10 SDI1 (HD/SD) input terminal (BNC)This is the SDI1 input terminal. (Compatiblewith HD/SD automatic switching, Compatiblewith 3G-SDI)When you use 3D assist mode (page 51), inputimages for the left eye (L).11 SDI1 active through output terminalThis terminal outputs SDI1 input as is.12 SDI2 (HD/SD) input terminal (BNC)This is the SDI2 input terminal. (Compatiblewith HD/SD automatic switching)When you use 3D assist mode (page 51), inputimages for the right eye (R).13 SDI2 active through output terminalThis terminal outputs SDI2 input as is.14 VIDEO/Y input terminal (BNC)This is the VIDEO signal (component signal)input terminal/Y signal (analog componentsignal) input terminal.15 PB /PR input terminal (BNC)This is the P B/PR signal (analog componentsignal) input terminal.16 VF terminal (D-SUB, 15 pins)This terminal connects to the VF (viewfinder)terminal of broadcasting and business camerasmade by Panasonic.The unit can be used as the viewfinder for sucha camera.17 GPI input terminal (D-SUB, 9 pins)External control is possible by using a GPIsignal.18 SERIAL terminal (D-SUB, 9 pins)External control is possible by using an RS-232C interface.19 HDMI input terminalThis is the HDMI input terminal.20 DC IN terminal (XLR, 4 pins)This is the external DC power supply inputterminal.When a DC power supply is connectedconcurrently with the battery, the externalpower input takes precedence.21 Battery holderThis holder is used with a battery made byAnton/Bauer. (page 14)22 Screw holes for fixing tripodThere are two screw holes on both the top andbottom for fixing the unit to a tripod (compatiblewith 3/8-16UNC). A removable adapter isinstalled in one of the screw holes on the topof the unit, and enables a 1/4-20UNC screwto fit in the screw hole. Decide whether touse the adapter depending on the diameterof the tripod’s fixing screw. Use a flat-bladescrewdriver to remove or install the adapter.23 Screw holes for multi-purpose fixingThere are four screw holes (M3) for multi-purpose fixing on the rear of the unit, and twoon each the left and right.Controls and Their Functions (continued)Rear panel1112 109 221921 2023 23131415161718229SERIAL