Panasonic BT-LH910G Operating Instructions Manual

Also see for BT-LH910G: Brochure Brochure Brochure & specs Operating instructions

3Read this first ! (continued)EMC NOTICE FOR THE PURCHASER/USER OF THE APPARATUS1. Applicable standards and operating environmentThe apparatus is compliant with:standards EN55103-1 and EN55103-2 2009, and•electromagnetic environments E1, E2, E3 and E4.•2. Pre-requisite conditions to achieving compliance with the above standards<1> Peripheral equipment to be connected to the apparatus and special connecting cablesThe purchaser/user is urged to use only equipment which has been recommended by us as•peripheral equipment to be connected to the apparatus.The purchaser/user is urged to use only the connecting cables described below.•<2> For the connecting cables, use shielded cables which suit the intended purpose of the apparatus.Video signal connecting cables•Use double shielded coaxial cables, which are designed for 75-ohm type high-frequencyapplications, for SDI (Serial Digital Interface).Coaxial cables, which are designed for 75-ohm type high-frequency applications, are recommendedfor analog video signals.Audio signal connecting cables•If your apparatus supports AES/EBU serial digital audio signals, use cables designed for AES/EBU.Use shielded cables, which provide quality performance for high-frequency transmission applications,for analog audio signals.Other connecting cables (IEEE1394, USB)•Use shielded cables, which provide quality performance for high-frequency applications, asconnecting cables.When connecting to the DVI signal terminal, use a cable with a ferrite core.•If your apparatus is supplied with ferrite core(s), they must be attached on cable(s) following•instructions in this manual.3. Performance levelThe performance level of the apparatus is equivalent to or better than the performance level required bythese standards.However, the apparatus may be adversely affected by interference if it is being used in an EMCenvironment, such as an area where strong electromagnetic fields are generated (by the presenceof signal transmission towers, cellular phones, etc.). In order to minimize the adverse effects of theinterference on the apparatus in cases like this, it is recommended that the following steps be taken withthe apparatus being affected and with its operating environment:1. Place the apparatus at a distance from the source of the interference.2. Change the direction of the apparatus.3. Change the connection method used for the apparatus.4. Connect the apparatus to another power outlet where the power is not shared by any otherappliances.Pursuant to at the directive 2004/108/EC, article 9(2)Panasonic Testing CentrePanasonic Service Europe, a division of Panasonic Marketing Europe GmbHWinsbergring 15, 22525 Hamburg, F.R. Germany