19On-screen Display (continued)Picture and volume adjusting knobs status displayPHASE CHROMAEXIT BRIGHT B.LIGHTPEAK F-IN-R20[PHASE] VOLUME CONT.CONT./B.LIGHTVOLUME/BRIGHTPEAK/PHASE CHROMAF-IN-RPicture adjusting knob (page 11)These are rotary push knobs.•If you press a knob, the setting value state•appears at the bottom left, and the item assignedto the corresponding knob is displayed at thebottom right.If multiple items are assigned to one knob, you•can press the knob to switch items.The indication disappears when you press•[ENTER] or after 10 seconds of inaction.Only adjustments that appear on the screen can•be adjusted.Status display:The status of an item can be identified by thedisplay color of the item name (page 11, “Pictureand volume adjusting knobs”).White: An item not target for adjustment.Green: An item target for adjustment.Gray: An item which cannot be adjusted.Sharpness displaySHARPNESS H 30Indicates the “SHARPNESS H/V” setting value of•the “VIDEO CONFIG” menu.If no operation is performed for 2 minutes,•the setting value is confirmed and the displaydisappears.Function displayF1:WFM/VECTORF2:PIXEL TO PIXELF3:FOCUS-IN-REDXXXXXUse the menu to open and set up functions.•When “FUNCTION DISPLAY” (page 39) is set•to ON1 or ON2, press any of the “FUNCTION1”to “FUNCTION3” buttons to display the functionsassigned to the FUNCTION buttons.In 3D assist mode (page 52), [FUNCTION3]•becomes the 2D picture quality adjustment modebutton.If no operation is performed for 2 seconds,•the setting value is confirmed and the displaydisappears.“XXXXX” indicates operating status (page 41,•“Functions displayed during FUNCTION buttonoperation”).