Panasonic BT-LH910G Operating Instructions Manual

Also see for BT-LH910G: Brochure Brochure Brochure & specs Operating instructions

36• When using the CA-210 display color analyzer,be sure to set the compensation values shownon the right. If they are not set, correct calibrationwill not be performed. For details on setupprocedures, refer to the CA-210 User's Guide.There is no compensation when using Display Color Analyzer CA-310.•Turn on this unit and perform adequate aging (about 1 hour) before starting calibration.•Make the room dark so that no external light can enter the standard measurement probe before starting•the calibration. If external light enters the probe, the low brightness characteristics may not be calibratedcorrectly.LCD panel characteristics and instrument error in the display color analyzer may sometimes result in small•differences in values after calibration.In a fine tuning of the monitor, also set GAIN and BIAS for R, G and B in the COLOR TEMP. VAR mode.Do not apply the probe to a WFM/VECTOR display on the screen.•CALIBRATION■Select CALIBRATION in the “SYSTEM CONFIG” menu to open the following menus.Sub menu Settings DescriptionAUTO CALIBRATION *1 ▼ Connect a CA-210 Display color analyzer and use thissubmenu to make a calibration.Select “AUTO CALIBRATION” and select “YES” in theconfirmation screen that appears to start calibration.RESET *2 ▼ Returns calibration data to their factory defaults.Select “RESET” and select “YES” in the confirmation screenthat appears to return calibrated values to their factory defaults.“EXECUTING” is displayed during “AUTO CALIBRATION” and “COMPLETE” appears when calibration*1ends. “INCOMPLETE” appears if calibration could not be completed.When “RESET” ends, “COMPLETE” appears.*2Performing AUTO CALIBRATIONPress [1. ][ ] in the “SYSTEM CONFIG”menu, select the [CALIBRATION] submenuand press [ENTER].Press [2. ][ ], select the [AUTOCALIBRATION] submenu and press [ENTER].MENU EXIT SEL. ENTER ENTER[AUTO CALIBRATION]YESNOSelect “YES” and press [ENTER].3.This starts calibration.MENU EXIT SEL. ENTER ENTER[AUTO CALIBRATION]xxxxxxxxxxxxxxxxx indicates that one of the followingmessages with the meaning listed belowappears.EXECUTING: Operation in progressCOMPLETE: Operation completedINCOMPLETE: Operation incompleted.(Check the SERIAL connection or display coloranalyzer connection.)Turn the power off and then on after4.performing auto calibration.Compensation W R G Bx 0.296 0.6534 0.2851 0.1485y 0.3036 0.3271 0.5927 0.0523Lv 203.4 43.18 148.1 15.5Main Menu (continued)