|
543D Assist Mode (continued)MIRROR (Left/Right and Top/Bottom inversion)This function inverts just the left and right or top and bottom or both the left and right and top and bottom ofthe input signals of SDI2 (R) to enable the basic adjustments of a rig-type 3D camera system (half mirrortype) to be made.TB MIRRMIRROR - - FUNC.Screen:The L/R 2 screens are shown side-by-side.Left and right inversion and top and bottom•inversion are also reflected in other assistfunctions.The inversion setting information is even saved•when the power is turned off.Sub menu Operation Settings DescriptionMIRROR Knob1 (turn) OFFLRTBLRTBInverts the left and right and the top and bottom of the inputsignals on the SDI2 (R) side. Do not invert Invert Left and Right Invert Top and Bottom Invert Both Left and Right/Top and BottomSHIFT (Horizontal and Vertical Shift)This function shifts the images of SDI2 (R) horizontally or vertically to enable you to overlay the images.You can check the lens axis of a rig-type camera system while checking the rotation offset of the image.H V - FUNC.0 0 SHFTScreen:L/R are overlaid in one screen.The setting information for shifting images withthe SHIFT function is not memorized. The initialdisplay state is restored when you switch to theCOMPARISON function or another assist function.Sub menu Operation Settings DescriptionH Knob1 (turn) -128 - 0 - 127 Shifts the images on the SDI2 (R) side horizontally.V Knob2 (turn) -32 - 0 - 31 Shifts the images on the SDI2 (R) side vertically.COMPARISON (Composition Check)This function is for checking when the subject is captured with only the camera of one side.--- FUNC.CMPRScreen:The L/R 2 screens are shown side-by-side, and a70% size half-tone marker is shown inside each ofthe images.If there is an image shown on either only the left orright, discomfort will be felt and stereoscopic visionwill become difficult when the mode is set to 3D.Perform a comparison check of the parts of theimages outside of the markers.The underlined values are factory preset setting values.The underlined values are factory preset setting values. PreviousNext |