4-6 DBS 576HD (USA) issued September 2001 576-50-700Chapter 7. SLT Features Section 700 - OperationSet Call Forward ID Codes for Voice MailDescription(For a description of Call Forward ID codes for Voice Mail, see “Call Forward ID Code for VoiceMail” on page 3-59.)Voice Mail Call Forward ID codes are used by voice mail systems to identify the correct mail box forstoring messages. The actual entry needed will vary by voice mail systems and configuration. Oftenthe entry is the extension number.OperationTo set the Call Forward ID code:Hardware Requirements• N/AAction Result1. If not already in User Maintenance mode, enter User Main-tenance mode. (See “To enter User Maintenance mode:” onpage 4-3.)81-User MAINT displays2. At the 81 level, enter 05.3. Press the HOLD key. 8105-C.FWD ID Code displays4. Press the HOLD key. CF ID-EXT Number displays5. Dial the extension number.6. Press the HOLD key. CF-ID EXT XXX displays (whereXXX = extension number)7. Enter the Call Forward ID code.Notes: The ID code may contain up to 16 digits and contain0, 1-9, *, #, pause (REDIAL key).To clear an entry or any existing data, press the FLASHkey.8. Press the HOLD key to store the entry. Next extension number displays9. To set additional Call Forward ID codes, press the volumeup or down key or press the HOLD key to move to thedesired extension.Desired extension displays10. Repeat steps 7-9 until all Call Forward ID codes are set.11. Press the AUTO key to exit the entry mode. CF ID-EXT Number displays12. To return to the top menu level (81), press the PROG key.OR...To exit the User Maintenance mode, press the ON/OFFkey.81-User MAINT displaysOR...ON/OFF LED goes off
