158During recordingSymptom Cause and Correction ReferencepagePressing the REC buttonwill not start recording.Is input image copy-guarded?Copy-guarded image cannot be recorded on this DVD Palmcorder. 68Recording starts butstops immediately.Is disc scratched or does dirt or fingerprints adhere to it?Clean the disc. If there is still no improvement, replace the disc. 78Is some other AV device directly connected to the video/audio input/output jack of this DVD Palmcorder?If the AV device is connected via several other devices, such as AVselector, the video signal may not be transmitted incorrectly. In sucha case, reduce the number of devices through which the video signalis transmitted, or connect AV device directly.67Are you attempting to record an image from a video game or PC?From some video games or PCs, images cannot be recorded on thisDVD Palmcorder.68LCD screen is hard tosee.Has brightness of LCD screen been adjusted?Stop recording and adjust the brightness. 93Is the DVD Palmcorder being used outdoors?Use the viewfinder. When using LCD monitor, adjust its angle so thatLCD screen is not exposed to direct sunlight.47, 49Focus is not correct. Is it difficult to use auto focus with your subject?Focus manually. 60Does “MF” appear?The DVD Palmcorder is set to manual focus. Focus the subjectmanually, or release manual focus.59Is the diopter control correctly adjusted if you are using theviewfinder as a monitor?Adjust the diopter control.48In cases other than the above, set the power switch to “POWEROFF”, and then set it to “ VIDEO”, “ PHOTO” or “ PHOTO”again.47Some vibrations are feltor slight sound is heardfrom mechanism.These vibrations or sound are caused by disc drive: This does notindicate a fault.
