160When the DVD Palmcorder is connected to PC:Symptom Cause and Correction ReferencepageNo drive icon appears onPC.The DVD Palmcorder is not turned on.Check the power supply. 47Driver is not properly recognized.Turn PC off and on again. If the drive icon still does not appear, use“Refresh driver” in Device Manager to reinstall the driver.Turn PC off and then disconnect the USB cable. Turn PC on again,and then use the USB cable to connect the DVD Palmcorder to PC. Make sure the USB cable is completely plugged into this DVDPalmcorder. If a yellow “!” mark is attached to some device in Windows ® DeviceManager, uninstall the USB device driver, and then reinstall it,following the procedure on page 137.A fatal exception 0A erroroccurs while installingUSB driver in Windows®2000 Professional.It is recommended that you install Windows ® 2000 Service Pack 3or later. Error occurs in playbackof DVD Palmcorder onPC.If error occurs with USB connection, the transfer rate is not sufficient.It is recommended that you use a USB terminal conforming toUSB2.0 when connecting the DVD Palmcorder.Application is notnormally run on PC.Turn the PC and DVD Palmcorder off, and try again. Error occurs duringwriting to DVD-R disc.The temperature of DVD Palmcorder is too high due to continuousoperation.Disconnect the DVD Palmcorder from PC once, remove the discfrom the DVD Palmcorder, and then turn it off. After a few moments,connect them again and write to a brand-new disc.Transfer of images stops. Connect the DVD Palmcorder to another USB terminal of PC. If yourPC is a desktop type, it is recommended that you use USB terminalon the back of PC. If you are using USB2.0 extended card, it is alsorecommended that you install the newest version driver provided byeach USB2.0 card maker.DVD-RAM/R/RW drivebuilt into PC cannot beused after the providedsoftware has beeninstalled.This problem may be solved if the software related to DVD-RAM/R/RW of your PC is upgraded, or if the UDF driver is uninstalled.However, with Windows ® 98 Second Edition / Me / 2000Professional, uninstalling the UDF driver will make it impossible forthe JPEG stills recorded on DVD-RAM of this DVD Palmcorder to beread by the PC.DVD-R disc cannot beplayed back on DVD-MovieAlbumSE.DVD-MovieAlbumSE does not support playback or data read onDVD-R disc: Use generally available DVD video playback softwareto play back DVD-R disc on PC.142Error appears whenstarting DVD-MovieAlbumSE.Make sure that your PC display adapter (video card) conforms toDirectX8.1. Video written to hard diskof PC cannot be editedon DVD-MovieAlbumcopy tool.DVD-MovieAlbumSE cannot edit DVD-VR data stored on hard diskof PC: Copy the data to another DVD-RAM disc and then edit it.
