3.1 Flow to introduceExamine about communication system such as communication style(1:1 topology, 1:1 topology with repeaters, 1:N topology), number ofconnected equipment, layout and so on.Consider the communication data amount, response time andmounting conditions at the same time.According the examined result, set wireless units to be required.(Read chapter 3 to chapter 5.)When introducing 1:1 topology, it’s set by only the main unit.When introducing 1:1 topology with repeaters or 1:N topology, it’s setby using setting tool.After completing all settings, proceeds the communication test byusing each test functions in setting tool. (Read chapter 6.)If the communication test is good, proceed test operation with theactual equipment.ExaminecommunicationsystemSetting wireless unit(Initial setting)(Slave registration)(Routing setting)Communication testIntroduction3.1.1 Flow to introduce “1:1 topology”Set Unit No., communication channel and MODE switches.For 1:1 topology, No.1 of MODE switch should be set to OFF.Reference: <3.2 Initial Setting of Wireless unit>Register slave at the master. Slave’s Unit No. should be registered as“01”. When operating mode switch is set to RUN, it can communicate.Reference: Set as the actual running conditions.Reference: <5.2 Setting and operation of “1:1 topology”>Initial setting ofmaster and slaveSlave registrationOperation duringrunning3-2Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
