(3) Turn power supply of master and slave on.Master Unit No.:00 Slave Unit No.: 01No.1:OFF Serial communication selection, baud rate, data length,parity should be set according to connected equipment.5.3 Setting and operation of“1:1 topology with repeaters”5.3.1 Setting contentsSetting flowAccording to the below flow it’s set. In this part it is assumed that setting of master and slave, slaveregistration are completed. If not yet, refer to chapter 3 and 4 first.Same communication channelReference： Reference： It is explained in this chapter.Proceed with “Master unit setup”→”New slave unit”→”Transfer toMaster Unit”→”Transfer From Main Unit”.※For changing methods <5.5 Change routing setting>It is explained in this chapter.Initial setting ofmaster/slaveSlave registrationRouting settingOperationduring running5-3Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
