3.2 Initial setting of wireless unitThis is the explanation about the setting of the main unit of wireless unit.Factory setting is as below figures.3.2.1 Setting of operating mode※At factory setting, it’s set to “SET”When setting by the main unit, it should be set to “SET”.When transferring setting such as "transfer to main unit" and so on by using setting tool, be sure toset to "SET".Other items such as "transfer from main unit", "communication test" are available in RUN mode.(Available with software version 1.20 or later.)Usage restriction in RUN modeItem Usage availabilityTransfer to Master Unit Not availableFile Transfer from Main Unit AvailableAddition (Addition of slave registration) Not availableRegistrationlist Delete (Delete slave registration) Not availableConfirmation of COM port connection AvailableConfirmation of status AvailableCommunication test AvailableField intensity monitor AvailableRead log AvailableInitialize Log Not availableRemote reset AvailableUtilityFlow control setting Not available*It is not available with software version 1.20 or less.*Use it in SET mode for “Not available”.Note: When setting, all wireless unit, master and slave, should be set to “SET”.After completing setting, set to “RUN” to start operation.When using test functions, set to “TEST”.3-4Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
