5.4 Setting and operation of “1:N topology”5.4.1 Setting contentsSetting flowAccording to the below flow it’s set. In this part it is assumed that setting of master and slave, slaveregistration are completed. If not yet, refer to chapter 3 and 4 first.Reference： Reference： It is explained in this chapter.Proceed with “Master setup” -> “New slave unit” -> “Transfer to MasterUnit” -> “Transfer From Main Unit”.*For changing methods <5.5 Change routing setting>It is explained in this chapter.5.4.2 Routing setting(1) Connect computer and master with RS232C cable. (RS485 type: MODE switch No.2 is set toOFF)(2) Turn power supply of master unit on with operating mode switch “SET”.(3) Boot setting tool.Initial setting ofmaster/slaveSlave registrationRouting settingOperationduring runningClick on the Windows [Start] button and then select "All Programs", "Panasonic-EW Control","Configurator", "Configurator KR", and "Configurator KR" on the displayed Windows menu, in thatorder.*From the left, there are 3 areas of “Registration list view”, “Routing table view” and “Terminal listview”.5-10Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
