4.1 Register slave4.1.1 Register slaveIn order to communicate master and slave, master recognizes slaves by registering slave to themaster. This process is necessary for all communication style, 1:1 topology, 1:1 topology withrepeaters, 1:N topology.According to the procedures in this chapter, register slaves at the master.At registration, slave is registered to master one by one by using only main unit or slaves areregistered by using the setting tool (Configurator KR).Max. 99 slaves can be registered to one master.Notes: 1. Do not register slave that is registered, to another master. (Master doubleregistration) It might cause malfunctions.2. “Be sure to register slave on the table before mounting.” You need to confirmLEDs of both master and slave.3. Slave can’t be registered via repeaters.4. During slave registration by main unit, do not execute serial communication norI/O communication. It can’t register correctly.5. Numbers of registration slave and Unit No. should be set as same as routingsetting.Reference: < Help in setting tool (Configurator KR) >4.1.2 Prepare master and slavePrepare all using wireless unit, master, slaves, and repeaters on the table.Note: When you use used wireless unit as another master or slave, initialize it once beforeusing. If software version is different each other, communication might not workwell. Check the version by setting tool. If it is different, please consult us.Reference: <5.9 Initialization><6.3.2 Confirmation of COM port connection> Main unit version check by setting tool4-2Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
