3.1.2 Flow to Introduce “1:1 topology with repeaters”Set Unit No., communication channel and MODE switches.With 1:1 topology with repeaters, MODE switch No.1 should be set toON.Reference: <3.2 Initial setting of wireless unit>Register slave at the master. All slaves’ registration is necessary.Reference: <4. Register slave>Set master setup and set routing setting of slaves and terminalequipment. Configurator KR (setting tool) is necessary to set.Reference: <5.3.2 Routing setting>Set as the actual running conditions.Reference: <5.3.3 Operation during running>Initial setting ofmaster and slaveSlave registrationRouting settingOperation duringrunning3.1.3 Flow to introduce “1:N topology”Set Unit No., communication channel and MODE switches.With 1:N topology, MODE switch No.1 should be set to ON.Reference: <3.2 Initial setting of wireless unit>Register slave at the master. All slaves’ registration is necessary.Reference: <4. Register slave>Set master setup and set routing setting of slaves and terminalequipment. Configurator KR (setting tool) is necessary to set.Reference: <5.4.2 Routing setting>Set as the actual running conditions.Reference: <5.4.3 Operation during running>Initial setting ofmaster and slaveOperation duringrunningRouting settingSlave registration3-3Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
