Panasonic KR20 User Manual

Contents

Panasonic KR20 User Manual Manual pdf 39 page image

3.2.2 Setting of communication channel※At factory setting, it’s set to “00”.Select the communication channel from ”00～F5”.Adding to the fixed channel, 76ch(00～４B), 89 group channel can be selected.Group channel is the function that it selects connectable channel from several fixed channelsautomatically. When using repeater function, use with the fixed channels.When using group channel, settable channel numbers are decreased in the same communicationarea and the communication time is longer.Master, slaves, repeaters in the same wireless system should be set to the same channel.Setting of communication channel will be available when turning power on again or changingoperating mode switch.Note： When using several channels in the same communication area, check there are noinfluences each other. It differs from the mounting conditions; max 15 channels areused as a standard. Do not use adjoining channels and use channel that separates5 or more (recommended).3.2.3 Setting of Unit No. (Master, Slave)※At factory setting, it’s set to “00”.Set Unit No. for master to “00”, for slaves and repeaters to “01～99”.With 1:1 topology, be sure to set it for slave to “01”. If not, it cannot communicate.Note: Within the same wireless system (same master), do not set the same Unit No. forseveral slaves. In addition, there is the function to prevent double registration forslave. (Slave double registration) Refer to <4. Register slave> in detail.3.2.4 Setting of MODE switches※At factory setting, it’s set as left figures.Set the setting of available/not available by 1:N topology setup, switchRS232C/RS485, Available/Not available of data holding, communicationconditions.・When setting of 1:1 topology, you can use as same as the setting during operation.・When setting of 1:1 topology with repeaters or 1:N topology, select RS232C for serialcommunication selection. It is required to use setting tool.3-5Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net