4.3 CONNECTING THE KX-TVP50 WITH THE PANASONIC KX-TD816 AND KX-TD123268 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX10. Start up completed.a) The Power Indicator light stops blinking when the start-up has been successful. (Thedelay varies according to the system's condition.)b) "**ON LINE MODE**" is displayed.c) System prompt [>] is displayed on the screen. To enter system administration, PressENTER. All parameters can be set through the menu-driven program.11.Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] thenQSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.Set the DIP switch to position 0 after initialisation is complete.4.3.2 KX-TD1232 Software Verification and Programming forDigital Integration via the Operating and Maintenance ToolFollow these steps after communication between the KX-TD1232 and the programmingsoftware has been established. Refer to the Operating and Maintenance manual forconnection information.1. Check the software version.a) Go to the Main Menu. Press the ALT key and the letter [V] at the same time.b) Verify the Operating and Maintenance version being used.This version must be 3.60X or higher to program the KX-TD1232 for DigitalIntegration.NoteIf you have an older version of the maintenance tool but have the correct ROMTEST: Press the INTERCOM button and then [165]. If the VPSanswers, you have a DPT connection.The required programming is complete and the VPS and KX-TD1232 should be able tocommunicate through Digital Integration.When running the Quick Setup command (Section 5 CUSTOMISING THE SYSTEM) fromthe VPS, the PBX transmits the station information automatically. This saves time whenprogramming the VPS.Sample display: DB data (PC): EmptyVersion:3.60X
