Panasonic LP-M Series Operation Manual
Also see for LP-S Series: Serial Communication GuideMaintenance GuideManual
                                                                                                                                                                                                                                                                                                                    | |
Contents
|
272ERRORCODE Error description MeasuresE605 Exceed valid number of characters.(Max. 30 characters/line.) Make numbers of characters smaller.E606 Existed marking data outside of marking area.Contain marking data within marking area.• Change marking position.• Make characters smaller.• Narrow character interval.* If there is no data out of the marking area in theimage display, check the “system offset” in theenvironment setting.“System offset” value is not shown in the imagedisplay.E607 Existed invalid character for bolding with setting font.• Set any standard font without original 4 font.• Use Font Maker provided to create the properpattern font.E608 Incorrect bold line width setting or character height/widthratio.• Set line width of bold character to half or belowof character height.• When marking the bold character, set thecomparison ratio between character height andwidth become 1/10 to 10.E610E612Lack of marking memory.• Marking data is too large.• The line length is too long. (spiral, etc.)• Reduce numbers of characters and logo data.• Reduce numbers of step & repeat.• Reduce numbers of a start point and a endpoint of characters or logo data.• Separate the long segment into short data.E620toE622Cannot follow line speed of flying object marking.Shorten marking time with the following methods.• Speed up scan speed.• Narrow character interval.• Make characters smaller.• Reduce numbers of characters.• Change setting of curve/edge.• Reduce numbers of character lines.• Displace a start point of marking, etc.Adjust the line speed of the flying object.Adjust the waiting time of the flying object.Set the coordinate of the marking data close tothe center of the marking field.E623 Too narrow marking interval for proportioned flyingobject.Increase setting value of marking spacing.Shorten marking time with the following methods.• Speed up scan speed.• Narrow character interval.• Make characters smaller.• Reduce numbers of characters.• Change setting of curve/edge.• Reduce numbers of character lines.• Set smaller value to the one-shot output time,etc.ME-LPMSZ-OP-7 |
Related manuals for Panasonic LP-S Series
This manual is suitable for:
LP-S SeriesLP-M SeriesLP-M200LP-M200-CHNLP-M200-SLP-M200-S-CHNLP-M205LP-M205-CHNLP-M205-SLP-M205-S-CHNLP-M500LP-M500-CHNLP-M500-SLP-M500-S-CHNLP-M505LP-M505-CHNLP-M505-SLP-M505-S-CHNLP-MA00LP-MA00-CHNLP-MA05LP-MA05-CHNLP-MA05-SLP-MA05-S-CHNLP-MA06LP-MA06-CHNLP-MA06-SLP-MA06-S-CHNLP-S200LP-S200-CHNLP-S200-SFLP-S202LP-S202-CHNLP-S202-SFLP-S205LP-S205-CHNLP-S205-SFLP-S500LP-S500-CHNLP-S500-SFLP-S500WLP-S500W-CHNLP-S502LP-S502-CHNLP-S502-SFLP-S505LP-S505-CHNLP-S505-SFLP-S505WLP-S505W-CHNLP-Z SeriesLP-Z130LP-Z130-CHNLP-Z250LP-Z250-CHNLP-Z256LP-Z256-CHN
manualsdatabase
Your AI-powered manual search engine