Chapter 4 Settings — [NETWORK] menu132 - ENGLISH[NETWORK SETUP]Perform the initial setting of the network before using the network function.1) Press as to select [NETWORK SETUP].2) Press the button.f The [NETWORK SETUP] screen is displayed.3) Press as to select an item, and change the settings according to the operation instructions of themenu.[PROJECTOR NAME] Allows to change the projector name. Enter the host name if it is required to use a DHCP server.[DHCP][ON] If a DHCP server exists in the network where the projector is to beconnected, obtains the IP address automatically.[OFF]If a DHCP server does not exist in the network where the projectoris to be connected, set [IP ADDRESS], [SUBNET MASK], and[DEFAULT GATEWAY].[IP ADDRESS] Enter the IP address when a DHCP server is not used.[SUBNET MASK] Enter the subnet mask when a DHCP server is not used.[DEFAULT GATEWAY] Enter the default gateway address when a DHCP server is not used.4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef When using a DHCP server, confirm that the DHCP server is running.f Consult your network administrator regarding the IP address, subnet mask, and default gateway.f The network setting is common for the terminal and the terminal.f [NETWORK SETUP] cannot be selected when the [NETWORK] menu → [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)].[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[COMMAND CONTROL] Set to [ON] to control with the control command format (x page 173) for the terminal.Refer to “Control commands via LAN” (x page 169).[COMMAND PORT] Set the port number used for command control.[Crestron Connected(TM)] Set to [ON] to control with Crestron Connected TM of Crestron Electronics, Inc.[AMX D.D.]Set to [ON] to control with the controller of AMX Corporation.Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, visit thewebsite of AMX Corporation.URL http://www.amx.com/[EXTRON XTP]Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the terminal.Set to [OFF] when connecting the optional DIGITAL LINK output supported device (Model No.:ET-YFB100G, ET-YFB200G).For details of the “XTP transmitter”, visit the website of Extron Electronics.URL http://www.extron.com/4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.