Chapter 4 Settings — Menu navigation62 - ENGLISH4) Press as to select a sub-menu, and press qw or the button to change or adjust settings.f Some items will switch in order as follows each time you press qw.A B Cf For some items, press qw to display an individual adjustment screen with a bar scale as shown below.0CONTRASTADJUSTNotef Pressing the Same operation is available by pressing the button on the remote control.f Some items or functions may not be adjusted or used for certain signals to be input to the projector. When the items cannot be adjusted orused, the items in the menu screen are shown in black characters, and they cannot be adjusted or set.If the item in the menu screen is displayed in black characters and the item cannot be adjusted or set, the factor causing it is displayed bypressing the button while the corresponding menu is selected.f Some items can be adjusted even if signals are not input.f Individual adjustment screen is cleared automatically if no operation is performed for approximately five seconds.f For menu items, refer to “Main menu” (x page 62) and “Sub-menu” (x page 63).f The cursor color depends on the setting in the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD DESIGN]. The selected itemis displayed with the yellow cursor by the factory default.f In the portrait setting, the on-screen menu is displayed sideways.To display the on-screen menu vertically, change the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSDROTATION].Resetting adjustment values to the factory defaultIf the button on the remote control is pressed, the values adjusted in the menu items are restored tothe factory default settings.button1) Press the button on the remote control.0CONTRASTADJUSTNotef You cannot reset all the settings to the factory default at a time.f To reset all the settings adjusted in the sub-menu item to the factory default one at a time, execute the [PROJECTOR SETUP] menu →[INITIALIZE].f Some items cannot be reset to the factory default settings even when the button on the remote control is pressed. Adjust thoseitems individually.f The triangular mark under the bar scale in the individual adjustment screen indicates the factory default setting. The position of the triangularmark varies according to the selected input signals.Current adjustment valueFactory default settingMain menuThe following items are in the main menu.When a main menu item is selected, the screen changes to a sub-menu selection screen.Main menu item Page[PICTURE] 66[POSITION] 72[ADVANCED MENU] 77