Chapter 3 Basic Operations — Operating with the remote control58 - ENGLISHUsing the status functionDisplay the status of the projector.button1) Press the button.f The [STATUS] screen is displayed.10000h10000h1.00 / 1.001/331°C/87°F27°C/80°F31°C/87°F31°C/87°F31°C/87°F1013hPaMENU EXITCHANGEENTER SEND E-MAILSELF TESTATMOSPHERIC PRESSUREAUTO - FLOORNO ERRORSCOOLING CONDITIONLIGHT TEMP. 2LIGHT TEMP. 1EXHAUST AIR TEMP.OPTICS MODULE TEMP.INTAKE AIR TEMP.MAIN/SUB VERSIONLIGHT RUNTIMEPROJECTOR RUNTIMEPROJECTOR TYPESTATUSRZ575(123456789012)Notef The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu → [STATUS](x page 117) for details.Using the ECO management functionDisplay the setting screen relating to ECO management.button1) Press the button.Notef Refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] (x page 101) for details.Setting ID number of the remote controlWhen you use the multiple projectors together, you can operate all the projectors simultaneously or each projectorindividually using a single remote control, if a unique ID number is assigned to each projector.After setting the ID number of the projector, set same ID number on the remote control.The factory default ID number of the projector is set to [ALL]. When using a single projector, press the ALL> button on the remote control. Also, you can control a projector by pressing the button onthe remote control even if you do not know the projector ID.button1) Press the button on the remote control.2) Within five seconds, press and set the one-digit or two-digit ID number set on the projector bodyusing the number (<0> - <9>) buttons.f If you press the button, you can control the projectors regardless of the ID number setting of theprojector body.Attentionf Since the ID number of the remote control can be set without the projector body, do not press the button on the remote controlcarelessly. If the button is pressed and no number (<0> - <9>) buttons are pressed within five seconds, the ID number returns toits original value before the button was pressed.
