Chapter 2 Getting Started — Setting upENGLISH - 31r Angle sensorThe range of the installation attitude that is detected by the angle sensor built-in the projector is as follows.30°30°Floor standing installationFloor standing installationProjection directionCeiling mount installationParts for installation (optional)The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings)) and Ceiling Mount Bracket (Model No.:ET-PKD130B (Projector Mount Bracket)).f Be sure to use the Ceiling Mount Bracket specified for this projector.f Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.Attentionf To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualifiedtechnician.Projected image and throw distanceInstall the projector referring to the projected image size and projection distance. Image size and image positioncan be adjusted in accordance with the screen size and screen position.f Following illustration is prepared on the assumption that the projected image size and position have beenaligned to fit full in the screen.SDLLSW SHSHSWHProjected imageScreenScreen(Unit: m)L Projection distanceSH Projected image heightSW Projected image widthH Distance from the lens center to the bottom edge of the projected imageSD Projected image sizeAttentionf Before setting up, read “Precautions for use” (x page 17).
