Powering ON/OFFENGLISH - 29 Basic OperationComplete peripheral connections (with a1 )computer, VCR, etc.) before turning on theprojector.Connect the projector’s AC power cord into an2 )AC outlet. The indicatorlights red. Open the lens cap.Press the <3 ) > button to on the controlpanel or on the remote control. The STANDBY(R)> indicator lights green and thecooling fans start to operate. The preparationdisplay appears on the screen and the countdown starts.After the countdown, the input source that was4 )selected the last time and the lamp power statusicon appear on the screen.If there is no signal input when start on the5 )projector, or the current signal is missed whileoperating the projector, the Video/Computerselection window will be displayed on the screen,please move the pointer to input source desiredby pressing the ▲▼ and the button.And then follow the input signal guidance windowto correct the signal and connection.If the projector is locked with a PIN code, PINcode input dialog box will appear. Enter the PINcode as instructed on the next page.NoteWhen the Logo select function is set to [Off], the logo willznot be shown on the screen (Æpage 54).When [Countdown off] or [Off] is selected in the Displayzfunction, the preparation display will not be shown on thescreen (Æpage 54).When the Input search function is set to [On 2], the inputzsignal will be searched automatically (Æpage 53).When the Direct on function is set to [On], the projectorzwill be turned on automatically by connecting the ACpower cord to an AC outlet.Turning On the Projector(2)(3)(3)Video/Computer selection06Selected input source and Lamp modeInput sourceThe preparation display will disappearafter 30 seconds.Preparation displayLamp power status