NetworkENGLISH - 63 SettingsDHCP(DHCP clientfunction)On: If a DHCP serverexists in thenetwork to whichthe projector isconnected, theIP address willautomatically beacquired.Off: If a DHCPserver doesnot exist in thenetwork to whichthe projectoris connected,additionally set[IP address],[Subnet mask] and [ Defaultgateway ].IP address(Displaying andsetting the IPaddress)Enter the IP addressif DHCP server is notused.Subnet mask(Displaying andsetting the subnetmask)Enter the the Subnetmask if not using aDHCP server.Default gateway(Displayingand setting thegateway address)Enter the gatewayaddress if DHCP serveris not used.DNS1(Displayingand setting thepreferred DNSserver address)Enter the DNS serveraddress if DHCP serveris not used.DNS2(Displayingand setting thealternate DNSserver address)Enter the alternate DNSserver address if DHCPserver is not used.Mode [No link], [DIGITAL LINK], [LPM] or[Ethernet] appearsHDMI status [NO HDMI], [HDMI ON] or [HDCPON] appears.The color of [Signal quality] will change to red, yellowor green depending on the maximum and minimumdata of the ERROR value.Signal quality Color Statusless than -12 dB Green Normal signal received-11 ~ -8 dB Yellow Part of the received datadestroyedmore than -7 dB Red Abnormal signal receivedProjector nameYou can change the projector name to be displayedon the network.Press ▲▼ to select [Projector name],1 )and press button.Select characters with the ▲▼◄►2 )buttons and press the button to enter the projector name.Select [BS] to delete one character selectedwith the cursor in the input box and press the button.Select [Set] with the ▲▼◄► buttons3 )and press the button.Select [Cancel] to undo the changes and thenpress the button.Select [Yes] or [No] with the ▲▼4 )buttons and press the button.Note[Namez ] ( is four-digit number) is setbefore the projector leaves the factory.Network setupYou can make detailed wired LAN settings.Press ▲▼ to select [Network setup],1 )and press button.Press ▲▼ to select an item, and2 )change the setting according to theinstructions.Press ▲▼◄► to select [Set], and press3 ) button.Default wired LAN settingszThe following settings are set before theprojector leaves the factory.DHCP OffIP address 192.168.10.100Subnet mask 255.255.255.0Default gateway 192.168.10.1DNS1/DNS2 NONENoteBefore using the DHCP server, make sure the DHCPzserver is already functioning.For details of IP address, subnet mask, gateway andzDNS, ask the network administrator.