Setting56 - ENGLISHSettingsOff Power management function is off.ReadyWhen the lamp has been fully cooleddown, the indicator changes to green blinking.In this condition, the projection lampwill be turned on if the input signalis reconnected or any button on thecontrol panel or remote control ispressed.ShutdownWhen the lamp has been fully cooleddown, the power will be turned off.TimerJPress ▲▼ to select [Timer] and then1 )press the button.Press ▲▼ to set the Timer(1~30 min).2 )Direct onPress ▲▼ to select [Direct on] and1 )then press the button.Press ▲▼ to switch between [On] and2 )[Off].When this function is set to [On], the projectorzwill be automatically turned on just byconnecting the AC power cord to a wall outlet.Be sure to turn off the projector properly. If thezprojector is turned off in the incorrect sequence,the Direct On function does not work properly.Standby modeThis function can set the electric power when theprojector is standing by.Press ▲▼ to select [Standby mode]1 )and then press the button.Press ▲▼ to switch between the items2 )as below.EcoRestricts some functions instandby mode to reduce powerconsumption.Network Does not restrict functionalityeven in standby mode.NoteWhen selecting [Network], the cooling fans may bezrunning depending on the temperature inside theprojector even if the projector is turned off.If Standby mode is set to [Eco], you cannot use networkzfunctions when the projector is standing by. Also, youcannot use some RS-232C protocol commands.If set to [Network], you can use network functions whenzthe projector is standing by.If [Standby mode] is set to [Eco], the signal come fromzMONITOR OUT and VARIABLE AUDIO OUT terminalsare unavailable.P-timerThis function allows you to change the setting of theP-timer and execute it.Press ▲▼ to select [P-timer].1 )Press ► or button to access2 )the submenu.ModeJPress ▲▼ button to select one mode1 )among the items as below.Count upThe P-timer display 000:00appears on the screen and thecount up starts (000:00-180:00).Count down The time set in the Timer settingappears on the screen and thecountdown starts.TimerJPress ▲▼ to select [Timer] and then1 )press the button.Press▲▼ to set the [Timer](1-180 min).2 ) Timer is available in [Count down] only. Factoryzdefault value is 10 min.ExecuteJPress ▲▼ to select one among the1 )items as below and then press the button.Start It executes the count up or countdown function.*1Reset Reset the P-timer values.*2Exit To exit the P-timer operation.Press the button at [Start] and the*1 :indication changes into [Stop]. To stop Count upor Count down, press the button at[Stop] on the screen menu, then the indicationchanges into [Restart]. Press the button at [Restart] to resume Count up or Countdown.Press the button at Reset to return to*2 :the following value: