62 - ENGLISHSettingsNetworkSelect [Network] from the Main Menu (see“Navigating through the menu” on page 37),then select the item from the sub-menu.Remote Control Control PanelDIGITAL LINK modeYou can switch the DIGITAL LINK function modeamong Auto, DIGITAL LINK and Ethernet.Press ▲▼ to select [DIGITAL LINK1 )mode].Press button and press ▲▼2 )to select items.AutoTo select the automaticallyresponse communicationmethod.DIGITAL LINK To select the DIGITAL LINK.Ethernet To select the Ethernet.Communication availability of all settingsSettings Communication availabilityImage, Sound Ethernet RS-232CAuto DIGITAL LINK Ethernet NoteTo carry out Ethernet communication with optionalzaccessory Digital interface box (ET-YFB100G), pleaseset to [Auto] or [DIGITAL LINK].If set to [Ethernet], communication can not be carriedzout with ET-YFB100G because the [LAN/DIGITAL LINK]terminal is only for NETWORK communication.DIGITAL LINK setupYou can make detailed DIGITAL LINK settings amongDuplex (Ethernet), Duplex (DIGITAL LINK) and Store.Press ▲▼ to select [DIGITAL LINK1 )setup].Press button or the ► button2 )to access to the submenu.Duplex (Ethernet)JSet the method of communication of the computer orhub.Press ▲▼ to select [Duplex (Ethernet)]1 )and press button.Press ▲▼ to switch the settings.2 )Autonegotiation Communication method willbe set automatically.100 Base TX-Full Full Duplex communicationmethod will be set.100 Base TX-Half Half Duplex communicationmethod will be set.Duplex (DIGITAL LINK)JSet the communication method between the Twistedpair cable Extender and the computer or the Hub.Press ▲▼ to select [Duplex (DIGITAL1 )LINK)] and press button.Press ▲▼ to switch the settings.2 )Autonegotiation Communication method willbe set automatically.100 Base TX-Full Full Duplex communicationmethod will be set.100 Base TX-Half Half Duplex communicationmethod will be set.StoreJStore the settings.Press ▲▼ to select [Store].1 )Press button.2 )A confirmation box appears and then selectz[Yes].DIGITAL LINK statusYou can check detailed setting information of DIGITALLINK.Press ▲▼ to select [DIGITAL LINK1 )status].Press button to display the2 )Mode, the HDMI Status and the Signalquality information.Link state, HDMI status and signal quality arezdisplayed.