32- ENGLISHBasic OperationProjectingCheck the connections of the peripheral devices and connection of the power cord (Æpages26-27) and switchon the power (Æpage29) to start the projector. Select the image and adjust the state of the image.Selecting the input signalSelect an input signal.The images selected using the button on the Control Panel or the , ,, (Æpage33).AttentionImages may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select azsystem format that is suitable for the input signal in [Component], [S-video] or [Video] under the [Input] menu (Æpage40).Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Screen] menuz(Æpage49).How to adjust the state of the imageAdjust the projection angle.1)Place the projector parallel to the screen, and then install it on a flat surface so that the screen becomeszrectangle.If the screen is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.zFor details, see “Adjusting front adjustable feet” (zÆpage 25).Adjust the lens shift.2)Adjust the projection position with the vertical lens shift ring.zFor details, see "Adjusting the position using the vertical lens shift function" (zÆpage 25).Adjust the zoom and the focus.3)Turn [Zoom lever] and [Focus lever] to adjust the image.NoteIt is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.zIf you adjust the focus, you may need to adjust the size of the image by moving the zoom lever again.zIf keystone distortion occurs, see “KEYSTONE” (zÆpage50).Focus leverZoom lever