Network62Network settingsItem Settings DescriptionNW link down detection Off♦ / On Specifies whether to detect disconnected network connection ofCamera port/Client PC.Bandwidth control Unlimited♦ / 32Kbps / 64Kbps /128Kbps / 256Kbps / 512Kbps /1024Kbps / 2Mbps / 5Mbps /10MbpsSpecifies the maximum rate for data transmitted to the network.• The transmission amount is not limited in the case of anMPEG-4 live image.Port forwarding Specifies whether port forwarding is enabled. To configure thissetting, click the [Setup >>] button.HTTP port number Port number input(80♦)Sets the HTTP port used when sending images in the range of1 to 65535. Normally this setting is 80.• Depending on network settings, changing the HTTP portnumber may make communication impossible. If thishappens, contact your network administrator.• Do not specify any of the following numbers for an FTP portnumber, site alarm port number, or port forwarding portnumber.20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 105, 110, 123, 161,162, 546, 547, 995, 10001, 10002, 10003, 10004, 10005,10006, 10007FTP port number Port number input(21♦)Specifies the recorder FTP port number in the range of 1 to65535. Normally this setting is 21.• Do not specify any of the following numbers for an HTTPport number, site alarm port number, or port forwarding portnumber.20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123, 161,162, 546, 547, 995, 10001, 10002, 10003, 10004, 10005,10006, 10007Network setup - Camera port/Client PC portDHCP Off♦ / On Specifies whether a DHCP server is used.• Select [On] to obtain the IP address, subnet mask, anddefault gateway from a DHCP server. Select [Off] to enterthem manually.IP address Address input *1 When [DHCP] is [Off], specify the IP address here.Subnet mask Address input *1 When [DHCP] is [Off], specify the subnet mask here.Default gateway Address input *1 When [DHCP] is [Off], specify the default gateway here.Line speed Auto♦ / 1000M-Full / 100M-Full /100M-Half / 10M-Full / 10M-HalfSpecifies the data line speed.Network setup - Maintenance portIP address Address input *1 Specifies the IP address.Subnet mask Address input *1 Specifies the subnet mask.DNS setupDNS Off♦ / Auto / Manual Specifies whether a DNS is used.• Selecting [Auto] enables auto detection of the DNS server.This setting is available only when [On] is selected for the[DHCP] setting of the Client PC port (page 61).• When [Manual] is selected, a primary address andsecondary address can be specified for the DNS server IPaddress.Primary server address Address input (0.0.0.0♦) Enter the IP address of the primary DNS server.Secondary server address Address input (0.0.0.0♦) Enter the IP address of the secondary DNS server.Domain name Name input (local domain♦) Enter the domain name of the recorder.• Enter up to 255 single-byte alpha-numeric characters,including hyphen (-) and period (.).• Use an alphabetic character as the first character of thedomain name.
