Maintenance79Use the following procedure to configure settings for operation when the HDD in the recorder becomes full. It also can be used to configure thewarning operation when the HDD becomes full.1 Click the [Maintenance] button on the setup menu.2 On the sub-menu that appears, click [Disk].This will display the "Disk setting" window.3 Configure the settings for each item.Refer to “Disk settings” table for details about the settings.4 Click the [Set] button.Disk settings♦Initial defaultDiskItem Settings DescriptionDisk end modeNormal recording area Continue♦ When the normal recording area becomes full, the oldest datais sequentially overwritten with new data.Event recording area Continue♦ / Stop Specifies operations when the event recording area becomesfull.• When the event recording area becomes full while[Continue] is selected, the oldest data is sequentiallyoverwritten with new data.• When the event recording area becomes full while [Stop] isselected, recording stops.Copy area Continue / Stop♦ Specifies operations when the copy area becomes full.• When the copy area becomes full while [Continue] isselected, the oldest data is sequentially overwritten with newdata.• When the copy area becomes full while [Stop] is selected,copying stops.HDD capacity warningNormal recording area Off♦ / 1% to 10% Configures settings for warnings issued when the remainingnormal recording area reaches a specified value.Event recording area Off♦ / 1% to 10% Configures settings for warnings issued when the remainingevent recording area becomes a specified value.Copy area Off / 1% to 10%♦ Configures settings for warnings issued when the remainingcopy area becomes a specified value.Hour meter warning 10000h / 20000h♦ / 30000h Configures settings for warnings issued when the remainingHDD operating time (hour meter) becomes a specified value.
