Panasonic WJ-NT204 Operating Instructions Manual

Also see for WJNT204 - NETWORK IF UNIT: Operating instructions

Contents

1254. In the SERIAL PORT SETUP window, click the Unit Address SETUP page for AUX SYSTEMS to open the PS.Data UnitAddress SETUP window.In the window, type in the device names for convenient when needed, then click the SET buttons for No. 001 through 005to register the PS.Data devices connected to the WJ-NT204 transmitter.Note: When a message “No Response” appears after clicking the SET button, confirm the connections and setups describedabove. Control Operation for WJ-HD500Type in the location bar http://192.168.0.10/ . The 192.168.0.10 in the URL may vary depending on the WJ-NT204 settings.Type the identical address to that the WJ-NT204 is set to. The WJ-HD500 OPERATION VIEW window appears.q Unit/System SELECTIONThis selection changes the Control Operation windowto that of the selected unit while communicating withthe unit.Pull down the button to display the registered title andPSD unit #. Select the respective unit number you wish.The window changes to the selected unit’s where youcan control it.Notes:• When you control combination cameras connected tothe WJ-HD500 via the WJ-MP204, select WJ-MP204 with this pull-down. Refer to WJ-MP204Data Multiplexer Control.• Specify Unit/System SELECTION first, then go to WJ-HD500 and CAMERA SELECT.w WJ-HD500 SELECTThese buttons select a WJ-HD500 when there are morethan one unit. No image will appear when clicking but-tons 2, 3, and 4 in this connection example.e CAMERA SELECTThese buttons select the input image of the cameraconnected to the WJ-HD500. The selected imageappears in the Image Display area of the window.r MULTISCREEN SELECTSelects a multiscreen pattern for live or playback imageeach time this button is clicked as follows.4 → 7 → 9 → 10 → 13 → 16 → 4 screen segmentst LIST/THUMBNAILDisplays the index of the recorded image in a list orthumbnail format. Clicking this button toggles the for-mat between list and thumbnail. The control panel forlist and thumbnail appears on the bottom center of thewindow.y ALARM RESETResets the alarm mode activated on the WJ-HD500,and stops the alarm recording.qwertyu i o !0 !1 !2 !3!4 !5 !6 !7 !8!9@0