Panasonic WJ-NT204 Operating Instructions Manual

Also see for WJNT204 - NETWORK IF UNIT: Operating instructions

Contents

15 WV-CU20 Remote Controller (Option)$5$6%1%2%5%4%3$1 $2 $3$4$7$8$9%9%0%6%7%8ESCMENUAF NEAR FARTELE WIDERemote Controller WV-CU201 2 34 5 67 8091 2 3 4 5#STEP 1DIALPRESET SETQUICKSTEP 2 STEP 3CALLREDIALDELETEENTERAUDIO MUTEALM ACKVIDEOSWITCHONE TOUCH DIALAUTO/MANUSITESERNO.$1 One-touch Dial Buttons [ONE TOUCH DIAL, 1 - 5]These buttons are used to call the destinations presetto the buttons. Press the DIAL, then any of them.$2 Switch Site Button[SWITCH SITE, 3]This button is used to switch the site from the currentlycommunicating to another one when communicatingwith more than one site. Highlight a site on the receivermonitor with the direction button, then press this button.$3 Video Scanning Mode Button[VIDEO AUTO/MANU, 4]This button is used on the receiver to toggle the scan-ning mode automatically and manually.$4 Alarm Acknowledge Button [ALM ACK, 5]This button is used on the receiver to acknowledge acti-vated alarms.$5 Dial Button [DIAL]This button is used to open the DIRECT DIAL windowwhere you can enter an IP address prior to start dialing.After pressing this button, specify an IP address fromthe registered directory or on the DIRECT DIAL window.To terminate the call, hold down this button for 2 sec-onds.$6 Quick Dial Button [QUICK]This button is used to select Quick (Short) Dial numbersstored in the menu.$77 Call Button [CALL]This button is used to call the IP address that may bepicked up from the registered directory or may beentered in the DIRECT DIAL window. After specifyingthe IP address, then press this button.$88 Redial Button [REDIAL]This button is used to redial the last called destination ifthe power of the unit has been tuned on after the call.The last called number is reset when the power of theWJ-NT204 is turned off.$9 # SET Button [#, SET]For camera selection, enter a camera number 1 through5, then press this button.For preset position selection, press [ , PRESET],[number], and this button.This is also used to confirm the selected parameter inthe setup menus, or to reset all parameters in the cam-era setup.%0 Delete Button [DELETE]This button is used to correct any numeric or alphabeticinput in the menu.Pressing this button will delete the character followedimmediately by the cursor.%1 Numeric Buttons [0 - 9]These buttons are used to enter numeric characters forphone numbers, passwords, and camera selection.%2 PRESET Button [ , PRESET]This button is used to specify a camera preset position.Press this button, [number], and then [#, SET] button torecall the camera preset position.In the camera setup menu, pressing this button willreset all parameters, or change the menu to SPECIAL.