Panasonic WJ-NT204 Operating Instructions Manual

Also see for WJNT204 - NETWORK IF UNIT: Operating instructions

Contents

36 100 CONFIGURATIONThis menu lets you set the operating mode and IP addressin the network.1. Press the MENU button on the Remote Controller toopen the 000 TOP menu.2. Select the 100 CONFIGURATION with the D or C but-ton, then press the ENTER button.3. Move the cursor to MODE and select either TRANSMIT-TER or RECEIVER. The default setting is TRANSMIT-TER.TRANSMITTER: Select this when the unit is installed inthe Remote site along with cameras.RECEIVER: Select this when the unit is installed in theControl site.4. Move the cursor to VIDEO and select H261 or JPEGwith the A or B button. A standard for video compres-sion is selected only for the TRANSMITTER.H261: The unit uses the H.261, ITU-T recommendation.JPEG: The unit uses the Joint Photographic ExpertsGroup standard. This standard is applicable onlywhen the PC site receives video transmission.5. Move the cursor to IP ADDRESS and enter the numberwith the numeric buttons.6. Move the cursor to SUBNET MASK and enter the num-ber with the numeric buttons.7. Move the cursor to DEFAULT GATEWAY and enter thenumber with the numeric buttons.Make certain that the default gateway is set to 0 whenthe system is used in the environment not having agateway.8. Move the cursor to the date and time field.Enter the month, date, year with the numeric buttons,then hour and minute. Press the ENTER.9. Move the cursor to DAYLIGHT SAVINGS and select ONor OFF with the A or B button. The default setting isOFF.ON: The internal clock advances by one hour than thenormal time.OFF: The normal time is applied to the clock.10. Move the cursor to TRANS. CONTROL and select ONor OFF with the A or B button. The default setting isON.This setting specifies whether the RECEIVER unit oper-ates or not the following functions such as camera con-trol, serial port control and parallel port control.ON: The unit is enabled to operate these control func-tions.OFF: The unit is disabled.Note: The priority is given to the presently operatingunit when ON is set to more than one unit, and acollision arises.11. The confirmation dialog prompts you to select YES orNO when pressing the ESC button after changing thesetting.YES: Select this when you wish to store the new(changed) settings.NO: Select this when you wish to retain the previoussettings.12. Press the ENTER to return the screen back to thestandby mode, or press the ESC button to go back tothe 000 TOP menu. In the standby mode, the monitordisplays camera pictures, not setup menus.000 TOP100 CONFIGURATION↓ (TRANSMITTER)200 RECEIVING REGI.↓300 DIRECTORY/DIALING REGI.↓400 SETUP↓500 CONTROL↓600 MAINTENANCE↓700 REMOTE SETUP EDIT↓↑↓:MOVE ENT:SELECT ESC:CLEAR100 CONFIGURATIONMODE : TRANSMITTER RECEIVERVIDEO : H261 JPEGIP ADDRESS : 192.168. 0. 10SUBNET MASK : 255 255.255.0DEFAULT GATEWAY : 0. 0. 0. 0DATE/CLOCKJAN.01.01 MON 00:00. . : SETMM.DD.YY HH:MMDAYLIGHT SAVINGS: ON OFFTRANS. CONTROL : ON OFF↑↓←→:MOVE ←→:SELECT DEL:CLR ESC:PRV CHANGE CONFIGURATION?YES NO←→:SELECT ENT:EXEC ESC:PRV